<big id="jhfvr"></big>

      <video id="jhfvr"></video><del id="jhfvr"></del>

        <pre id="jhfvr"></pre>

              歡迎您訪福州豐潤電氣有限公司官方網站
              banner
              美國柏勒夫Marsh

               

              Type 5000

              Type 5000

              產品詳細

              Type 5000 P/I Transducers
              • 0.1% accuracy typical
              • Piezo resistive pressure sensor resists vibration
              • Mounts at any angle
              • Easily accessible zero and span adjustments
              • NEMA 4X housing approved for explosion proof service
              Product Detail:

              The Type 5000 series is a compact, rugged and reliable family of two-wire pressure transmitters designed for industrial field service. These instruments convert a signal pressure input into a precise 4-20 or 10-50mA output. The lightweight transmitter housing includes a 1/4 NPT pressure port and a 1/2 NPT conduit port for field wiring. Connections are easily accessible simply by removing the top cover. Zero and span adjustments are available within the field wiring compartment for fine, on-site calibration adjustment. The Type 5000 uses a unique, temperature compensated piezo resistive sensor suitable for gauge pressure measurement of non-corrosive liquids and gases. The sensor has excellent dynamic response and is virtually insensitive to mounting orientation and ordinary industrial vibration. Mounting holes on the transmitter housing are arranged to permit direct pipe (2") mounting for minimum installed cost.

              NEMA 4X Enclosure
              The Type 5000 transducers have been certified by Factory Mutual Research as meeting the requirements for NEMA 4X (water tight, dust and corrosion resistant).

              The transducers also have Factory Mutual approvals for:

              1. Explosion proof service (Class 1, Divisions 1 and 2, Groups B, C & D)
              2. Dust ignition proof service (Class II, Divisions 1 and 2, Groups E, F & G)
              3. Class III, Divisions 1 and 2. Equivalents to the above approvals have been obtained from the Canadian Standards Association.
              Part Numbers:
              Create Part Number:
              9
              6
              4
              X
              X
              1
              0
              XX
               
              0
                0-15 psig (0-1.0 BAR) Input
              1
                3-15 psig (0.2-1.0 BAR)
              2
                3-27 psig (0.2-1.9 BAR)
              3
                6-30 psig (0.4-2.1 BAR)
              4
                0.2-1.0 BAR (3-15 psig)
              5
                0-100 psig (0-6.9 BAR)
               
              0
                4-20 mA Output
              1
                10-50 mA
               
              1
                X/P FM/CSA Agency Approval
               
              00
              None Options
              06
              Pipe Clamp Mounting Kit
              Options:
              Consult Factory.

               


              分享到:

               

               

              上一條:Type 3512/3522  

              下一條:Type 10

              點擊次數:點擊代碼  更新時間:2011-9-30 20:28:20  【打印此頁】  【關閉

               

               

               

              二維碼

               

              聯系我們 | 網站地圖 Copyright 2016 福州豐潤電氣有限公司 版權所有 | 網站備案/許可證號: 閩ICP備16038147號-1   網站建設信和網絡